GPM Racing Aluminium Hex Adapters 8mm Thick-12pcs Set for Traxxas 1/10 Ford GT 4-Tec 2.0 (GT010/12X8MM)

Precision hex adapters for GT4

Engineered for TRAXXAS GT4 TEC 2.0 4WD applications, these hex adapters deliver a direct axle-to-wheel load path with a tight tolerance interface. The parts are CNC machined from 6061 T6 aluminium and dimensioned at 8mm thickness to align with common axle-mounted wheel hex geometries.

The adapter profile is optimised to reduce clearance and torsional play between the wheel hex and axle, aiding repeatable alignment during setup and competitive tuning. This product is intended for RC axle and wheel connection only and must not be used on full-size vehicles.

Standard mounting hardware is supplied for assembly: the pack contains 2x10 steel pins and 2x5 stainless steel cap head screws to secure the hex to the axle hub. The hex thickness is 8mm and the original brake disk thickness is specified at 6.8mm as a reference for clearance checks.

Packing includes

• 2x10 Steel Pin - 4pcs
• 2x5 Stainless Steel Cap Head Screw - 4pcs

This item is compatible with

• TRAXXAS FORD GT4-TEC 2.0
• ELEMENT RC-1/10 ENDURO SENDERO-40100

What tolerances should I expect?

Manufactured to tight CNC tolerances for consistent hex runout, these adapters aim to minimise lateral and angular play when matched to the correct GT4 axle and wheel interfaces.

Recommended inspection after fitting?

After installation check wheel runout and ensure pins and cap screws are secure. Verify clearance using the listed 6.8mm brake disk thickness as reference where applicable.

Material and service life?

6061 T6 aluminium provides a good balance of strength and weight for upgrade use; inspect mounting hardware periodically for wear and replace pins if deformation is observed. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM's factory, so please allow around 14 days for dispatch.