GPM Racing Aluminium Wheel Hub Hex (+2mm) for Traxxas 1/10 MAXX (TXMS010+2M/2)

Precision machined aluminium hub hex for TRAXXAS MAXX

The TXMS010+2M/2 aluminium wheel hub hex is an aftermarket replacement engineered for the TRAXXAS MAXX MONSTER TRUCK platform. It transmits drive through the CVD to the wheel and is intended to maintain consistent rotation and reduce drive losses under load.

Manufactured from 6061 T6 aluminium and finished with machined mating faces, the hex set increases local stiffness compared with stamped or plastic parts. The 7.5mm thickness and +2mm offset provide a modest track increase to enhance lateral stability, and the machined face reduces wheel-to-hub slop for firmer engagement.

Supplied as an 8pcs matched set, the kit contains four hub hex pieces and four 2.5x14 steel pins for retention. Install where a small track change and improved wheel retention are desired for setup refinement or to replace worn hexes.

Original Name / Part No:

8956

Specifications

• Item: Aluminium wheel hub hex +2mm, 8pcs set (four hub hex + four 2.5x14 steel pins)
• Material: 6061 T6 aluminium
• Model Number: TXMS010+2M/2
• Compatibility: TRAXXAS MAXX MONSTER TRUCK

As a direct-fit aftermarket hub hex for the MAXX, this precision machined aluminium part improves track geometry and wheel retention to support setup tuning and longer component life.

This item is compatible with

• TRAXXAS-1/10 MAXX MONSTER TRUCK-89076-4

What checks are recommended before installation?

Verify axle/CVD interface dimensions and wheel inner face clearance. Confirm pin orientation and torque settings during final assembly to ensure correct retention.

How does the +2mm offset alter handling setup?

A wider track shifts lateral load distribution slightly. Inspect roll behaviour and fine tune camber, toe and shock preload as required to re-establish balance after fitting.

What maintenance is advised for aluminium hexes?

Regularly inspect for wear and burrs on the mating face and check pin retention. Clean and lightly lubricate mating surfaces if corrosion or debris is present to preserve fit.

Is any additional hardware recommended?

The supplied 2.5x14 steel pins provide basic retention. For heavy use consider verifying pin grade and replacing with higher grade hardware if required by your application. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM's factory, so please allow around 14 days for dispatch.